Segway Power Station Cube Error Code E10

"Car output overload or short-circuit"

If your Segway Power Station Cube is beeping or has a red wrench icon and flashes this code, read below.

If you clicked the wrong error code, go back to the Power Station Cube Error Code Index.

Previous Error Code: Segway Power Station Cube Error Code E09 - Next Error Code: Segway Power Station Cube Error Code E11

Cause

This error is likely caused by the 12v dc car-style output port drawing more than 10A.

Fix

Disconnect the loads. Turn off the DC output after 5 seconds and try again later

Make sure the device connected to the car port is not drawing more than 10A and there are no frayed wires or shorts.